University of Kansas · University of Florida · Florida International University

Hardware security, taught inside the courses students already take.

Most cybersecurity courses still treat the processor and the board as a root of trust. These modules do not add a hardware-security elective. Each one is a lab on a topic the host course already teaches: the instruction set, the stack, the timer, CMOS switching, the adder, the state machine, or the cache.

  1. M1Binary reverse engineeringEmbedded systems
  2. M2Buffer overflowEmbedded systems
  3. M3Timing side channelEmbedded systems
  4. M4Board reverse engineeringEmbedded systems
  5. M5Power side channelDigital logic
  6. M6Combinational logic lockingDigital logic
  7. M7Hardware Trojan insertionDigital logic
  8. M8Sequential logic lockingDigital logic
  9. M9Cache side channelComputer architecture
9modules across three core courses
5security topics across the nine modules
25survey responses from three offerings
3modules at most in one semester

A separate course does not reach the students who need this.

Limited reach

The elective is taken by a few.

At the University of Florida, fewer than 7% of undergraduate electrical and computer engineering students register for the introductory hardware security course in a given year. Students who never enroll in that elective do not see reverse engineering, side-channel analysis, or logic locking.

Cost

A new course is expensive to keep.

A dedicated course needs an instructor who already knows the subject, a lab of special equipment, and a slot in a crowded curriculum. Teaching-focused departments compete for a hire they are unlikely to make. A course taken by a small fraction of the majors is hard to justify.

Fragmented view

The attack is taught apart from the circuit.

Many of these failures start in the implementation. A timing leak comes from data-dependent control flow. A power leak comes from CMOS switching current. Both are properties of the circuit the student is already designing, not topics to postpone until a later elective.

A security topic belongs in a core course when the lab requires a design concept already on the syllabus. Running the attack, or building the countermeasure, is how the student practices that concept.

The selection principle

Nine modules

Three have survey data from embedded systems. Two more have been taught. Four are written and ready to run. Pick at most three in a term.

Where they sit

Each module is scheduled in the week the host course covers the design topic it uses. The lab keeps the debugger, the vendor tools, and the bench instruments the course already has.

Computer architecture

The memory hierarchy as a channel

  1. Cache side channel

Each module adds about 30 to 40 minutes of lecture. The rest replaces a lab or homework the course already assigned.

See the course map

Support

This work was supported in part by the U.S. National Science Foundation (NSF) Secure and Trustworthy Cyberspace (SaTC) program under Award No. 2114157.

Any opinions, findings, and conclusions or recommendations expressed in this material are those of the authors and do not necessarily reflect the views of the U.S. National Science Foundation.

The project is a collaboration of the University of Kansas, the University of Florida, and Florida International University.